Similarly, if the system is rebooted with the web browser command Control Program
Reboot and if the parameter button pressed hold until the status led blinks, again the
system starts up with the factory defaults.
Note that the factory default parameters are restored into the operational memories
when the above mentioned steps are applied. The previously programmed parameters
(if any) are still in the nonvolatile memories until the web browser command Save is
operated.
Restoring the Programmed Parameters:
Whenever the Save command is operated, all the parameters in the operational
memories are transferred into the nonvolatile memories.
This being the case, it is possible to restore the programmed parameters unless the
Save command has been operated. To do this, just power up or reboot the system
without any button pressed hold. Then, any parameters in the non-volatile memories
are loaded into the operational memories and the system will start with these
parameters.
This page is left blank intentionally
44
To Next Page
Loading...