Telesystem PALCO LS10 - Antenna and System Settings; Antenna Configuration Guide; Restore Factory Settings

TELE System
Impostazione Antenna
the basic settings to allow the use of the TV with a single Universal LNB (Low Noise
Block converter) system (commonly used for satellite systems in Italy); in the event
your system is done with a different configuration, you must appropriately change the
antenna settings.
WARNING! The wrong antenna configuration can result in the failure to load some or
all channels. If you do not know the characteristics of your antenna system and/or
are unable to properly configure the receiver yourself, you may want to consult a
professional installer for advice. The power and signal quality indicators refer to the
first transponder of the chosen satellite list
Restore Factory Settings
This function allows you to restore factory settings. To do so, select
Restore settings
... and on the new screen, select YES. The television will be restored to its factory
settings.
WARNING! Restoring the factory settings starts the installation wizard (see section
"First Installation"), and also clears all previously memorized channels and settings
set by the user.
Technical specs
Display
Diagonal 18,5” (47 cm) 16:9 Wide
Resolution
1366(H) x 768(V) – HD READY
Contrast ratio
700:1
Brightness
150 (cd/m
2
)
Angle of view
178°/178° (H/V)
Inputs
SCART
1
HDMI
1
A/V in
1YPbPr (Adapter not included)
USB
1 – Mediaplayer
Audio output
Coaxial
TV Signal
RF input DVB-T
75 Ω – VHF/UHF - 7MHz/8MHz
RF input DVB-S
1 tipo F
Video
MPEG-2, MPEG-4, H.265.Main@L4.1-
1920*1080@60fps
Audio
MPEG1 layer1/2; DD; DD+; AAC; HE-AAC
Speaker
2 x 3 Watt
Specs
Power supply
100V – 240V ~ 50/60Hz / 12V DC 3A
Consumption
<0,5W in Stand-by; <36W Max
Supported
format
AVI/MP4/MKV (compatible H.265)
Size (w x h x
d)
With stand
440 x 302 x 143 mm
Without stand
440 x 271 x 69 mm