TELE System
Incorrect antenna configuration may result in some or all channels not being loaded. If you do not
know the characteristics of your antenna system and/or you are not able to configure the receiver
yourself, it is advisable to contact a trusted professional installer.
The Signal and Quality Level indicators refer to the transponder of the selected satellite indicated
on the screen. Make sure that it is valid/updated and actually active.
It is not recommended to avoid connecting the TV to the satellite signal through the pass-through
antenna connector (LNB Out / Loop Through) of an external satellite receiver as both devices cannot
operate simultaneously. When the TV is switched on, the receiver must be in standby (with the
tuner not powered) and vice versa.
available on the menu (without deleting the channels list).
Factory reset (reset)
It is possible to reset the entire television, returning all the settings to the initial condition. To do
so, select Settings> Reset in the Home menu (connected Smart/TV mode) and confirm. Another
way to do this is: Home> Settings> Other Settings > Common Settings> System Restore.
WARNING
Restoring the factory settings deletes all the customizations made by the user, including stored
channels, downloaded applications and changed settings. Furthermore, by confirming the reset, the
TV will perform a complete system rebook and then display the first installation wizard on the
screen.
To Next Page
