2
MAINS PRESSURE DOMESTIC HOT WATER APPLIANCE
STORAGE
CAPACITY
IN LITRES
90
125
150
170
200
250
300
Tempest & Tornado Stainless
Mains pressure domestic hot water cylinder
WARNING TO USER:
This appliance must be serviced annually by a competent person.
Failure to comply with the above will invalidate the manufacturer’s
warranty.
Do not remove or adjust any component part of this unvented
water heater: Contact the installer.
If this unvented water heater develops a fault, such as a flow of hot
water from the discharge pipe, switch the heater off and contact
the installer.
WARNING TO INSTALLER:
This installation is subject to building regulation approval, notify
Local Authority of intention to install.
Use only manufacturer’s recommended replacement parts.
Installed by:
Name: ..................................................................................
Address: ..............................................................................
.............................................................................................
Tel. No.: ...............................................................................
Completion Date: .................................................................
Water Supply Pressure
Max
12 Bar
Min
1.5Bar
Electric Immersion Heaters
14“/3kW • 230V AC
Operating Pressure
3 BAR
Expansion Vessel charge Pressure
3 BAR
Expansion relief valve setting
5 BAR
Pressure & Temperature relief valve setting
7 BAR • 90ºC
Maximum Primary working Pressure
3 BAR
APPLIANCE SERIAL NO:
Weight and litre capacity
Indirect Direct
Technical help line: 01952 257961
Telford Copper Cylinders Limited Unit 22 Furrows Business Park Telford TF1 2FE
WEIGHT
WHEN FULL
IN KGS
125
165
195
220
250
310
360
Ltrs Kgs
To Next Page
