EasyManuals Logo

Telit Wireless Solutions FN990 Series Hardware Design Guide

Telit Wireless Solutions FN990 Series
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
FN990 Family Hardware Design Guide
1VV0301752 8
Page 65 of 83
2024-05-29
12.2 Americas Approvals
USA FCC
FCC Certificates
The FCC Grants can be found here: https://www.fcc.gov/oet/ea/fccid
Applicable FCC Rules
Table 50: Applicable FCC Rules
Model
Applicable FCC Rules
FN990A28
47 CFR Part 2, 15, 22, 24, 27, 90, 96
FN990A40
FCC Regulatory Notices
Modification Statement
Telit has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment.
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Wireless Notice
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines. This
transmitter must not be co-located or operate in conjunction with any other antenna or
transmitter. The antenna should be installed and operated with a minimum distance of
20 cm between the radiator and your body
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used per the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by taking one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.

Other manuals for Telit Wireless Solutions FN990 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions FN990 Series and is the answer not in the manual?

Telit Wireless Solutions FN990 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelFN990 Series
CategoryComputer Hardware
LanguageEnglish