•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to
an OEM or integrator but should not be distributed to the end user.
1. This device is intended for OEM integrators only.
2. Please see the full Grant of Equipment document for other restrictions
Manual Information to the End User
The OEM integrator should be aware not to provide information to the end-user on how
to install or remove this RF module in the user’s manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warming as shown in this manual
Information on test modes and additional testing requirement
The module has been evaluated in mobile stand-alone conditions. For operational
conditions other than a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…). If this module is intended for use in a portable
device, you are responsible for separate approval to satisfy the SAR requirements of FCC
Part 2.1093.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only authorized by the FCC for the specific rule parts (for
example, FCC transmitter rules) listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host
not covered by the modular transmitter grant of certification. If the grantee markets their
product as being Part 15 Subpart B compliant (when it also contains unintentional-radiator
digital circuity), then the grantee shall provide a notice stating that the final host product
still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
The end product with an embedded module may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15.
FCC Antenna info
This radio transmitter has been approved by FCC to operate with the antenna types listed
below with the maximum allowable gain indicated. Antenna types not included in this list,
with a gain greater than the maximum gain indicated for that type, are strictly prohibited
from use with this device.
To Next Page
Loading...
Need help?
General