TL113005
Ford E-350/450 Cutaway Installation Manual with Telma Control Module (TRCM)
Page 2 of 30__________________________________________________________________________17feb12jh
TABLE OF CONTENTS
1 Preparation of the Chassis
1.1 Driveline
1.2 Exhaust
2 Telma Installation
2.1 Installation Kit TIK10677
2.2 Install the Chassis Brackets
2.3 Install vent tube extension
2.4 Assemble the Telma Brackets and mounts
2.5 Install the Telma in the Chassis
2.6 Drive Shaft Modification and Installation
2.7 Axle Shim Installation
3 Control Components
3.1 Relay Box Installation
3.2 Light Bar Installation
3.3 Telma Control module and Foot Control Switch Installation
3.4 Foot Switch Adjustment
4 Wiring Harness Installation
4.1 Power Harness Installation
4.2 Control Harness Installation
4.3 Wiring Diagram
5 Recommended Tools
6 Post Install Checklist
Appendix
(1.1) E350 138” WB with 5.4L engine
(1.2) E350 138” WB with 6.0L/6.8L engine
(1.3) E350/450 158” WB with 5.4L engine
(1.3.1) E350/450 158” WB with 6.0L/6.8L engine
(1.4) E350/450 176” WB with 6.0L/6.8L engine (X1=24)
(1.4.1) E350/450 176” WB with 6.0L/6.8L engine (X1=22.5 / L1= original)
(1.4.2) E350/450 176” WB with 6.0L/6.8L engine (X1=10)
(1.4.3) E350/450 158 to 176” WB with 6.0L/6.8L engine (stretch in front of x-member)
(1.5) E350/450 186” WB with 6.0L/6.8L engine (stretched chassis)
(1.5.1) E350/450 158 to 186” WB with 6.0L/6.8L engine (stretch in front of x-member)
(1.6) E350/450 190” WB with 6.0L/6.8L engine (stretched chassis)
(1.6.1) E350/450 158 to 190” WB with 6.0L/6.8L engine (stretch in front of x-member)
(1.7) E350/450 208” WB with 6.0L/6.8L engine (stretched chassis)
(1.7.1) E350/450 158 to 208” WB with 6.0L/6.8L engine (stretch in front of x-member)
To Next Page