Remove the package and check that the machine is
undamaged.
If you have any doubts, do not use the machine and call on a
qualified technician. Keep all packing parts (plastic bag,
foam rubber, screws etc.) out of the reach of children since
they could be dangerous.
The inside of the washing machine which
consists of a floating unit, is fixed with screws and tabs at the
back of the cabinet (Fig.1) during transport. Before starting
the machine remember to release the floating unit by
removing the above screws and take down the reinforcing
iron piece. To prevent water spray from entering the machine,
remember to close the holes left open by the screws with the
plastic caps provided in the packet containing the owner's
manual. And rescrew the holes where the iron piece is taken
down with the former two screws.Attention:keep the packing
screws and plastic caps in a safe place for later use. It is
important for the machine to be perfectly level (the angle of
inclination on the work surface must not be more than 2
degrees). For this reason the machine is fitted with
adjustable feet used for levelling the machine before use
(Fig.2). In the case of flooring with carpeting, remember to
check that the ventilation in the support area is not plugged.
Important:
Fig.1
Unpacking
levelling and
positioning
4
Installation
Fig.2
Solution to Problems
17
Check that:
the transit bolts have been removed (see
installation manual);
the machine is level;
the washing load is according to the instructions
given in this booklet.
The machine
vibrates too
much when
spinning
The machine
stops operating
before finishing
Check that:
there is a sudden power failure or water stop.
the machine is in the normal state of rinse.
To Next Page
Loading...