Telpo 4FXS - Page 74

Voice Gateway 4FXS User Manual
- 74 -
The parameter is the time value of resent command, and unit is second.
MGC platform setting command of H.248
Interaction setting mode
protocol_ep1> mgcmode
After only entering “mgcmode” command, the command will inquire users about
the MGC platform that will be set. See below:
MGC Mode:
[0] DEFAULT
[1] HW
[2] ZTE
[3] BELL
Input your choice[0~3]:
At this time only numbers chosen from 0～3 can be input. If the users want to give up
the settings, they are able to button “Ctrl＋C” or directly button enter key to get
out of priority setting state.
Non-interaction setting mode
protocol_ep1>mgcmode {parameter}
Only numbers chosen from 0～3 can be input, which stands for the three MGC
platforms under interaction mode.
Command to set H.248 command delay
protocol_ep1> cmddelay {parameter}
The parameter is the time value of command delay, and unit is ms.
Parameter displaying command
protocol_ep1> show {parameter}