Telpo 4FXS - Parameter Effect-Taking Command; SNMP-Related Parameter Setting Command Set

Voice Gateway 4FXS User Manual
- 83 -
＃show private
( "*" means the Running Config Value)
Private IP: 10.25.101.1
OLT: 255
ONU: 255
Current status: CONFIGING
If the parameter is “epsatus”, the system will remind to input port number after the
command is performed. Once entered, the state of the port number, including actived
state, registered MGC state, hookswitch state, linking state and signal state, etc., will
be shown, for instance:
# show epstatus
Please input endpoint index(0 for MG status) (0 ~ 24): 1
POTS1 Status
Act: ACTIVED
Port: REGISTERING
Reg: REGISTERING
Hook: HOOK_ON
Conn: IDLE
Sig: IDLE
6.2.8 Parameter Effect-taking Command
＃ take-effect
The command does not need any parameter. It is adopted to force the current all
configured values to take effect.
6.2.9 SNMP-related Parameter Setting Command Set
Command to enable or disable snmp setting
#manage/snmp> switch { parameter }
This command is to turn on or off the snmp module. The parameter only can be
“on” or “off“. “on” means to turn on snmp function; and “off” means to turn