TP-8/16/24/32/64S User Manual Version No.: V1.2
- 76 -
Download command
system> download {parameter1} {parameter2} {parameter3}
Parameter 1 only can be “config”, pf0”, pf1”, pf2” or “program”. Of them, “program” refers to
procedure mapping files, others refer to parameter configuration files, they are required to be relative
to the different parts of Flash respectively. Parameter 2 is the IP address of server, for instance,
192.168.1.3. Parameter 3 is the name of server port document, for example:
system> download config 192.168.1.3 cfg-pf2
system> download program 192.168.1.3 prog
Upload command
system> upload {parameter1} {parameter2} {parameter3}
Usage is similar with download command.
Internet interface information display command
system> ifshow
This command does not need any parameter. It is transplanted into ifconfig command of busybox, and
used to display network access information, but is without configuration function. For example:
eth0 Link encap:Ethernet HWaddr 00:1D:2B:02:AB:0C
inet6 addr: fe80::21d:2bff:fe02:ab0c/64 Scope:Link
UP BROADCAST RUNNING MTU:1500 Metric:1
RX packets:736646 errors:0 dropped:0 overruns:0 frame:0
TX packets:471395 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RXbytes:63351556(60.4 MiB) TXbytes:31267836
Interrupt:1
Manual-cancellation endpoint command
system>logoutep
This command is performed by way of interaction, it does not need any parameter. It is used to force
endpoint to be canceled from MGC, so as to forbid this endpoint’s NGN business. After the command
is executed, CLI will display the following information:
system> logoutep
Start endpoint (1~24): 1
Number of endpoints (1~24): 1
POTS1 Status
Act:
Port:
Reg:
Hook: HOOK_ON
Conn: IDLE
Sig: IDLE
Among them, “Start endpoint” is the operating start endpoint number, beginning with 1; and “Number
of endpoint” refers to the quantity of the operating endpoints, it is at least 1, but is not allowed to
exceed the practical endpoint number.
To Next Page
Loading...