To Next PageTo Next Page
Need help?Do you have a question about the Temptek VETERAN LS Series and is the answer not in the manual?
Crucial safety considerations and owner's responsibility for proper operation and maintenance.
Connecting the unit to the water supply, detailing pressure requirements and recommendations.
Instructions for connecting the unit to the electrical power supply, emphasizing voltage requirements.
Steps for system fill, electric motor phasing, and process flow adjustments for initial operation.
Procedures for starting up and operating the instrument, including setpoint adjustments and status lights.
Precautions and steps for safely shutting down and disconnecting the unit from the system.
Diagnosing issues when the unit does not power on, checking fuses and transformer.
Troubleshooting common reasons for the unit not starting despite power being on.
Diagnosing why the unit unexpectedly stops during operation, checking supply and safety conditions.
Identifying and resolving causes of unit overheating, such as water pressure or valve issues.
Troubleshooting low process temperatures, including water leakage or heater element failure.
Step-by-step procedure for replacing the pump seal, including disassembly and reassembly.
Detailed instructions for safely removing and replacing the unit's heater element.
General| Display | Dual 4-digit LED |
|---|---|
| Control Mode | PID, On/Off |
| Input Type | Thermocouple, RTD |
| Output Type | Relay, Analog |
| Power Supply | 100-240 VAC, 24 VDC |
| Communication | RS-485 (Modbus RTU) |
| Dimensions | 48 x 48 x 100 mm |
