TENAMIC HB Series - SETTING THE USER CODE; SETTING THE MASTER CODE

E-mail: tenamic@aliyun.com 04
SETTING THE USER CODE
● With the door open, press the reset button, start setting code when the yellow light goes on.
● Input new code (3-8 digits), and press the “*” or “#” button to confirm, it will be confirmed by 2 buzzer
beeps and the yellow light flashes twice.
● If the yellow light flashes with 3 buzzer beeps, which means the code changing is not effective, and you need
to try again.
SETTING THE MASTER CODE
● With the door open, press “00” and press the reset button, start setting code when the yellow light goes on.
● Input new code (3-8 digits), and press the “*” or “#” button to confirm, it will be confirmed by 2 buzzer
beeps and the yellow light flashes twice.
● If the yellow light flashes with 3 buzzer beeps, which means the code changing is not effective, and you need
to try again.