9
EN
Please read before use
Tenderflame 90 and 180 Burner
This user guide is for all our replaces. For replace installation,
please refer to the chapter for each individual replace.
The following is included:
Tank — Wick unit — Tank gauge — Glass — Extinguisher
Assembly instructions
1. Remove all packaging.
2. Place the two glasses in the grooves on each side of the wick.
User Guide
1. Wet the wick with Tenderfuel before use. Slowly pour the liquid
over the entire wick. Then, ll the tank through the opening.
2. The tank of the 180 burner is full when the red mark on the tank
gauge is above the top plate. The tank of the 90 burner is full when
the red indicator is pointing straight up (see illustration page 2).
3. Light the wick at both ends with a Tenderflame lighter or any
other replace lighter. Hold the lighter to the wick for about
10 seconds. The replace may emit a slight odour the rst
few times it is used, as well as when it is extinguished. The
flame may take a few minutes to reach its full size
4. Never leave a burning flame unattended.
5. Only use Tenderfuel fuel. The lifetime warranty for the
wick is only valid when Tenderfuel is used.
6. NEVER USE BIOETHANOL OR PARAFFIN OIL!
7. Avoid refuelling while the wick is burning.
8. The burner should never be covered or moved while in use. Must
not be used as anything other than a decorative replace.
9. If spilled, the fuel can be wiped up with a cloth.
To Next Page
Loading...