Tenker SM9126N - User Manual

Questions and Answers

J
Juan RobinsonAug 2, 2025
What to do if I don't feel the intensity on my Tenker Massager?
- J
  Jeremy SimsAug 2, 2025
  If you're not feeling the intensity even at a weak setting on your Tenker Massager, there are several possible reasons: * Ensure both pads are firmly attached to your skin. * Remove any transparent films from the pad's adhesive surface. * Make sure the pads are not stacked or overlapping. * Verify the cord is correctly connected to the unit. * Increase the intensity level. * Charge the battery if it's low. * Clean the adhesive surface of the pads gently with your fingertips under slow running water for about 3 seconds if they are dirty or dry. * Reduce the application time or the intensity if they are set too high.
K
Kylie HarrisAug 8, 2025
How to fix a Tenker SM9126N with no power and no display?
- C
  Courtney MorrisonAug 8, 2025
  If your Tenker Massager has no power and the LCD isn't displaying anything, the battery is likely depleted. Charge the battery to resolve this issue.
K
Kyle FisherAug 13, 2025
Why does my Tenker SM9126N power off during use?
- M
  Mark RandallAug 13, 2025
  If your Tenker Massager is cutting off during use, it could be due to a weak battery. Try charging the battery. Another possibility is a broken cord, in which case you should replace the cord.
C
campbellmatthewAug 17, 2025
Why is it hard to attach the pad to my Tenker SM9126N?
- A
  Anthony ChenAug 17, 2025
  If you're finding it difficult to attach the pad to your skin when using the Tenker Massager: * Ensure you've peeled off the transparent film from the adhesive surface of the pad. * If you've just washed the pad, make sure it's fully dry before applying it. * If the adhesive surface is damaged, it might be time to replace the pad.
V
Vincent JohnsonAug 23, 2025
What to do if the adhesive pad of my Tenker Massager is not sticky?
- E
  Elizabeth BennettAug 23, 2025
  If the adhesive surface of your Tenker Massager pad isn't sticky: * The pads may be deteriorating, contact the vendor for replacements. * If the pads were stored under high temperature, high humidity, or direct sunshine, replace the pad.
R
romerobettyAug 28, 2025
Why does one pad feel stronger than the other on my Tenker Massager?
- M
  msmithAug 28, 2025
  It's normal for one pad to feel stronger than the other on your Tenker Massager. Different areas of your body will react differently. Ensure that the pads are moist and making good contact.

Summary

Safety Notes

Important Safety Warnings

Key safety precautions for device usage, including avoiding specific body areas and user groups.

Introduction

Safety Warnings

Danger

Critical warnings for individuals with implanted medical devices or monitoring equipment.

Warning

Consult a physician if you have specific medical conditions before using the device.

Notice

General usage notices, including avoiding certain activities and locations, and child safety.

Transport and Storage Symbols

Cleaning and Maintenance

Product Specifications

Set Up

Operating the Product

Mode Introduction

Recommend Use Positions

Lower Back

How to apply pads to the lower back area for effective massage.

Sciatic

Recommended pad placement for sciatic pain relief.

Deltoid

Guidance on placing pads for deltoid muscle massage.

Arm

Instructions for applying pads to the arm for massage.

Recommended Practice

Trouble Shooting

Warranty Card

Contact Information

Tenker SM9126N Specifications

General

Model	SM9126N
Category	Massager
Application	Neck, Shoulder, Back, Waist, Legs
Heat Function	Yes
Massage Nodes	8
Intensity Levels	3
Timer	15 minutes
Functions	Kneading
Heat Temperature	40-45°C
Auto Shut-off	Yes