To Next PageTo Next Page
Need help?Do you have a question about the TENNADYNE T10 and is the answer not in the manual?
Technical specifications including frequency, gain, SWR, dimensions, and wind ratings.
Critical warning about the dangers of power line contact with antennas.
Advice on organizing parts and tools before beginning assembly.
Outline of the five distinct phases for assembling the antenna.
General guidance on the assembly process, including lubrication and environmental considerations.
Detailed steps for preparing boom sections, including precise measurements and part placement.
Specific instruction for installing the choke plate before completing certain boom sections.
Instructions for joining boom sections using splice inserts and fasteners.
Guidance on turning booms upside down and covering holes after splicing.
Steps for installing spacers and assembling the two main booms together.
Critical check for correct alternating placement of elements on both booms.
Detailed steps for attaching each element to the boom sections.
Instruction to compare assembly to photos and install the shorting stub.
Detailed guide on constructing and attaching the coaxial balun (choke).
Instructions for mounting the boom-mast insulator and attaching the antenna to a mast.
General| Type | Log Periodic Dipole Array |
|---|---|
| Frequency Range | 13-30 MHz |
| Gain | 7 dBi |
| Polarization | Horizontal |
| Input Impedance | 50 Ohms |
| Front-to-Back Ratio | 20 dB |
| Connector Type | SO-239 |
| VSWR | 1.5:1 |
| Power Handling | 2000 W |
| Mounting | Mast |
