TennaTronix TurboTuner-2

Questions and Answers

C
clawsonAug 13, 2025
What to do if TennaTronix Controller TurboTuner-2 is dead?
- K
  Kimberly JonesAug 13, 2025
  If your TennaTronix Controller (TurboTuner-2) is dead, doesn't beep at startup, and tuning won't start, check the interface cable to ensure it's connected to the TUNER CONTROL SOCKET on the back of the radio. Also, verify that the fuse inside the radio is not blown.
J
Jessica WallaceAug 17, 2025
Why won’t my TennaTronix TurboTuner-2 antenna tune on certain bands?
- P
  Paula CharlesAug 17, 2025
  If the TennaTronix Controller antenna won’t tune on certain bands, ensure proper installation and grounding. Use the radio bar-graph display or a separate SWR meter to verify actual SWR. You may also try changing DIP Switch 5 setting to ALTERNATE SWR mode.
J
James LaneAug 21, 2025
Why does my TennaTronix Controller TurboTuner-2 initiate a park sequence on its own?
- D
  dhensleyAug 21, 2025
  If the TennaTronix Controller (TurboTuner-2) initiates a 'park' sequence on its own, it could be due to an anomaly detected in the RF signal. Ensure the RF cable is connected, and verify proper system grounding and choking of the RF cable and motor cable.
J
Jeffrey StanleyAug 25, 2025
What to do if TennaTronix TurboTuner-2 Controller antenna moves in wrong direction?
- M
  Michael MorrisAug 26, 2025
  If, when changing frequency, the TennaTronix Controller antenna moves in the wrong direction, change DIP Switch 1 setting.
A
adamsmichaelAug 28, 2025
Why does my TennaTronix Controller TurboTuner-2 beep three times?
- C
  Cynthia JohnsonAug 29, 2025
  If your TennaTronix Controller (TurboTuner-2) beeps a series of three 'S' sounds, it indicates a serial communication error. Ensure all radio configuration items are set as described.
F
fgardnerSep 1, 2025
Why TennaTronix Controller antenna does not reverse at end of travel?
- S
  Sara GarciaSep 1, 2025
  If the TennaTronix Controller antenna does not reverse at the end of travel, it may be because the stall current is set too high.
M
Miss Ashley BrownSep 5, 2025
Why does TennaTronix TurboTuner-2 Controller antenna reverse before the end of travel?
- A
  aperezSep 5, 2025
  If the TennaTronix Controller antenna reverses direction before reaching the end of travel, it could be because the stall current is set too low.
T
Teresa HernandezSep 8, 2025
How to fix TUNER/CALL button on TennaTronix TurboTuner-2 Controller?
- J
  Jonathan HurleySep 8, 2025
  If the TUNER/CALL button on your TennaTronix Controller does not work, ensure all the radio configuration items are set correctly and that the selected frequency is within the band.