What to do if the TensCare Uniglo Massager output will not increase above zero?
If the TensCare Massager output won't increase above zero, the open circuit cut-out may be operating due to a lead not connected properly or being faulty. Ensure the device is correctly attached to your body. Try using the second lead wire. If needed, purchase a replacement.
Why do I feel no sensation with TensCare Massager?
If you experience no sensation with the TensCare Massager, especially while using FACE 2, the intensity might be too low. Increase the strength setting. Most users feel something below 20 mA. Note that this program uses microcurrent, and it's normal not to feel anything.
How to fix TensCare Uniglo with no display?
If there is no display on your TensCare Massager, it could be due to flat batteries. Try recharging the batteries. If the battery is damaged, contact the supplier.
What to do if TensCare Uniglo shows low battery?
If your TensCare Massager displays a low battery warning, it likely means the batteries are low. Recharge the batteries to resolve this.
To Next Page
General