AC Over-
voltage
High
Input
Voltage
1. Ff the voltage surpasses 270Vac for
level 2 or 140Vac for level 1 for a short
duration, the charger will enter standby
mode and conduct a power network check
to restore itself to the normal voltage range.
Once the voltage is within normal range, the
charger will automatically resume charging.
2. If the voltage in the local area or
community remains over 270Vac for
level 2 or 140Vac for level 1 for a prolonged
period, the user should refrain from using
the charger until the voltage returns to the
normal range.
Relay
Failure
CP/CC
Error
Charger
CP/CC
Connection
Error
Relay
Failure or
Adhesion
1. Please check whether the charging plug
is securely and firmly connected to the
vehicle's inlet socket.
2. If the problem persists, please do not
hesitate to contact us for further assistance.
1. Try restarting the charger and allow it to
run its internal self-diagnostic and repair
routines.
2. If the problem persists even after
restarting the charger, please do not hesitate
to contact us for further assistance.
14
To Next Page
Loading...