Terex RL4000D2 Series - Shutdown Procedures; Lowering the Tower

November 2006
P
a
r
t
N
o
.
8
3
3
0
0
5
R
e
v
A
R
L
4
0
0
0
L
i
g
h
t
T
o
w
e
r
1
7
OPERATING INSTRUCTIONS
LIGHT TOWER AUXILIA
RY PO
WER:
1.
One 20 amp, 120 V
AC GFI receptacle
and one 30 amp, 240 V
AC receptacle are prov
ided
for auxiliary power.
2.
T
otal auxiliary power cannot
exceed main circuit breaker rat
ing. Each lamp operating
consumes 9.5 amps of 120
volt power.
3.
Before plugging in
auxiliary power
cords, feed t
hem up through
the trailer fr
ame and
attach to receptacles. Close the cabinet doors to
protect control panel and other
components from weather.
SHUTDOWN PROCEDURES:
1.
Place all lig
ht switc
hes into the
ir “OFF” posi
tion.
2.
Allow the engine to run for 1 t
o 5 minutes under no load, then
turn the unit “OFF”.
Ne
ver shut
the unit
down
while un
der load. The
AC gene
rator
may become damaged.
Af
ter b
ein
g sh
ut
do
wn
, the li
gh
ts
mu
st
be all
ow
ed to
co
ol
down before trying to r
estart the
light
s. T
his coo
l down
period c
an be betwee
n 10-
25 minutes, depe
nding
on t
he
ambient temperature.
LOWERING THE TOWER:
1.
Using the upper
telescoping winch,
telescope the t
ower down to
its fully ret
racted
position.
The
boom sho
uld lower smoot
hly and eve
nly to it
s lowest
posit
ion. If it does not, contact a qua
lifi
ed me
chanic.
Insure the
coil co
rd does not become e
ntangled with the
lower tower se
ctio
ns.