Need help?Do you have a question about the TERK Technologies AF-1 and is the answer not in the manual?
General| Weight | 1.5 lbs |
|---|---|
| Color | Black |
| Impedance | 75 Ohms |
| Connector Type | F-Type |
| Frequency Range | FM: 88-108 MHz |
Explains gain control for adjusting amplifier intensity and LED behavior.
Describes the antenna's dual tuning modes: Wideband and Narrowband Tuning.
Position antenna away from electronic devices to maximize performance.
Keep antenna away from large metal objects; windows often provide best results.
Move antenna if no signal is received; metal-frame buildings may cause issues.
For weak signals, ensure receiver's scan button is in the off position.
Pull AM loop 90° from FM antenna for optimal AM results; AM portion is non-amplified.
Connects using an 'F' type connector to the FM antenna input.
Use supplied adapters; connect transformer leads to receiver's antenna input terminals.
Connects AM leads with U-clips to receiver's AM screws or push-buttons.
Plug power adapter into switched outlet or wall outlet, then into FM connector.
Rotate dial clockwise until all LEDs are red for Wideband mode.
Rotate dial counter-clockwise; one red LED indicates Narrowband tuning.
Addresses issues like antenna not working with boom boxes or extending FM antenna wire.
Explains why touching antenna improves reception and how to judge its working state.
Details the one-year warranty against defects, limitations, and contact information.
To Next Page