What does 'DF' mean on my Termal TMCZ 105 F?
If your Termal Air Conditioner displays 'DF', this is a normal process that protects the system from icing and potential failure. The unit will automatically restart after about 15 minutes, depending on the function setting, and this procedure will repeat as needed.
What to do if my Termal TMCZ 105 F shows error code 'E4'?
If your Termal Air Conditioner displays 'E4', it means the water tank is full. To resolve this, remove the rubber cap at the bottom of the unit and drain the water into an external container. Once the water is completely drained, you can restart the unit.
What does error code 'E1' mean on my Termal Air Conditioner and how to fix it?
If your Termal Air Conditioner displays error code 'E1', it indicates that the room temperature is outside the function range. Check the operating instructions for the correct function range. Take a new measurement of the starting temperature. Turn the unit off, wait about 30 minutes, and then restart it. If the error continues, the unit needs to be checked by an Authorized Technical Service.
What does error code 'E3' mean on a Termal TMCZ 105 F?
If your Termal Air Conditioner displays error code 'E3', it indicates an incorrect signal. Please observe the instructions relating to ideal operation of the Unit. Error Code E3 may also be referred to a temporary error measurement between the start and output temperature. Turn the unit off, wait about 30 minutes, and then restart it. If the error continues, the unit needs to be checked by an Authorized Technical Service.
General| Brand | Termal |
|---|---|
| Model | TMCZ 105 F |
| Category | Air Conditioner |
| Language | English |
Provides an introduction and technical overview of the mobile air conditioner.
Explains warning/caution levels and the meaning of symbols used in the manual.
Provides critical safety instructions for moving, placing, and cleaning the unit.
Details the physical components of the TMCZ 105 F mobile air conditioner.
Provides crucial operational guidelines and warnings for using the unit.
Explains the functions of various buttons and the LED display on the operating panel.
Describes the functions of each button on the infrared remote control.
Details how to operate the unit for cooling inside a room.
Explains how to use the unit for heating inside a room effectively.
Describes the process of extracting humidity from the air and its operational requirements.
Outlines procedures for cleaning the exterior and air filters of the unit.
Lists common errors, their causes, and suggested remedies for troubleshooting.
To Next Page