FOR STEAM IRONING
HOW TO FILL THE TANK WITH WATER
• Always unplug the iron from the outlet when filling the boiler with water.
• Remove the cap (5) slowly pour the water through opening by using the provided
funnel to avoid any leakage. Put the cap back on.
• Only use running water to fill the tank without exceeding its maximum
capacity: never add detergents, chemical additives or water softeners.
SUGGESTION: If water in your area is particularly calcareous, it is advisable to
use distilled water.
STARTING UP
• Rest the appliance on a firm flat surface.
• Place the iron on the boiler base (3).
• Fill up the water tank as described in the previous paragraph.
• Completely unwind the power cord (7) and plug into the outlet.
• Press the on/off button (2) on the boiler taking it to (ON).
• Turn the iron temperature control knob (13) to the steam ironing position.
• The pilot light (14) on the iron will go on immediately and will go out a few minutes later,
when the required temperature is reached.
• When the pilot light (8 ) goes on, it is possible to use the jet of steam.
• During operation, the iron light (14) and the “steam ready” pilot light (8 ) go on and
then automatically go out indicating that the iron temperature are constantly under
control.
• Rest the iron on the boiler base (3) during ironing pauses.
USE INSTRUCTIONS
CHOICE OF THE IRON TEMPERATURE
Turn the iron temperature control knob (13) so that the proper temperature corresponds
to the indicator (12) according to the type of cloth to be ironed.
High temperature steam ironing (cotton, linen)
Medium temperature steam ironing (wool, silk)
Low temperature ironing (synthetic, bres)
Fig.: 1
ENGLISH
To Next Page
Loading...
