ENGLISH
REPLACING THE FILTER-BAG
This operation must be performed with the appliance
turned off and the plug removed from the wall socket.
Replace the lter regularly to prevent loss of vacuuming
power and breakage of the bag because too full.
• Open the dust bag cover by pulling its handle (Fig. 4).
• To remove the lter bag, grasp the cardboard placed at the
base of the lter bag (13) and pull it up (Fig. 5).
• Insert the new lter bag by sliding the cardboard into the seat
in the lter bag compartment (Figure 6).
Important: for a correct mounting, follow the direction of
the arrow on the cardboard (Fig. 7).
• Close the cover (9) by rst inserting its lower part and then
pressing on the top until it is correctly locked.
WARNING!
Make sure that the cover (9) IS FULLY CLOSED. If not,
repeat until when the cover is mounted correctly.
Fig. 7
Fig. 4
Fig. 6
Fig. 5
To Next Page
Loading...
