ASSEMBLY INSTRUCTIONS cont.
STEP 3
Rest the second the end profile on top of the slats as shown. Use the
wood screws to attach the mount and all of the slats.
STEP 3a STEP 3b
Assembly Instructions cont. - 5
STEP 4
Place a Wheel cap on the soft surface with the curved side down.
Center the axle over the exposed opening and tap the top end of axle
with a hammer. The cap should look level once completed.
TIP: It is recommended to use a rubber hammer or place a soft material
between the hammer and Wheel Cap to avoid blemishing the Wheel Cap.
To Next Page
Loading...