EasyManua.ls Logo

Tesla 2012- 21013 S - Active Air Suspension

Tesla 2012- 21013 S
145 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Active Air Suspension
USING THE TOUCHSCREEN 5.11
Active Air Suspension
Automatic Height Adjustments
If Model S is equipped with Active Air
Suspension, the system adjusts the height
based on driving speed. It also maintains a level
height between the front and rear when
carrying loads.
NOTE: When Model S starts, you might hear the
sound of a compressor as the system’s
reservoir fills with air.
If Model S is moving, Active Air Suspension
adjusts height as follows:
Whenever you drive between 90 and 115
km/h, the suspension lowers to Low to
improve aerodynamics and handling. When
your driving slows to less than 65 km/h, the
suspension raises back to Standard.
Whenever you drive over 115 km/h, the
suspension immediately lowers to Low.
Whenever you drive at a speed less than
40 km/h, the suspension immediately
raises to Standard.
If you set the suspension to Low, then drive
over 7 km/h, the suspension reverts to
Standard.
If you set the suspension to Very High, then
drive over 15 km/h, the suspension lowers
to High.
If you set the suspension to High, then drive
over 30 km/h, the suspension lowers to
Standard.
After driving, the height of the suspension
periodically levels, even when Model S is
powered off.
If a fault is detected with the air
suspension system, a yellow indicator
displays on the instrument panel. If the
problem persists, contact Tesla.
Manual Height Adjustments
CAUTION: Before adjusting the
suspension height, ensure Model S is
clear of all obstacles above and below.
Use the touchscreen to manually change the
height of Model S. Press the brake pedal and
touch Controls. Then choose from:
Very High - The suspension raises 33 mm
above its normal height. Useful for extra
ground clearance (ramps, speed bumps,
etc).
High - The suspension raises 23 mm above
its normal height. Useful for extra ground
clearance (ramps, speed bumps, etc).
Standard - The default height. This setting
ensures optimum comfort and handling
under all loading conditions.
Low - The suspension lowers 20 mm below
its normal height. Useful for loading or
unloading cargo and passengers.
NOTE: Available settings depend on your
driving speed and other conditions. For
example, the suspension does not lower if a
door is open.
Jack Mode
Before jacking or lifting, set the suspension to
Jack mode to prevent the self-leveling that
occurs even when Model S is powered off.
Press the brake pedal, then touch
Controls > Jack.
When Model S is in Jack mode, a red air
suspension indicator displays on the
instrument panel.
To deactivate, touch Jack again.
NOTE: Jack mode automatically cancels when
you drive over 7 km/h.
book.book Page 11 Tuesday, September 17, 2013 12:33 PM

Table of Contents

Related product manuals