Tesla IR302BL - Cleaning and Maintenance

5
2. During use, the anti drip system may emit a loud clicking
sound, particularly during heat-up or whilst cooling down.
This is perfectly normal and indicates that the system is
functioning correctly.
ANTI SCALE
The build-in anti-scale cartridge is designed to reduce the
build-up of limescale which occurs during steam ironing.
This will prolong the working life of your iron. However,
please note that the anti-scale cartridge will not completely
stop the natural process of limescale build-up.
Temperature and steam settings table
CLEANING AND MAINTENANCE
Simple Repair Methods
Caution: Indicates that the fabric is not ironing
Instructions on Label Type of Fabric Thermostat Dial
Nylon
Silk
MIN
MAX
Wool
Cotton
Linen, jeans
Before cleaning, remove the plug from the socket and allow the iron to cool down sufficiently.
1. Wipe off the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
2. If the fiber is adhered to the soleplate, use a damp cloth with vinegar to wipe off the soleplate.
3. Never use strong acid or alkali in order to avoid damaging the soleplate.
4. If the scale blocks the steam hole, please remove the scale with toothpick; do not damage the surface of soleplate.
5. Stand the iron on its end and let it cool down sufficiently, and meantime pour any remaining water out of the box, set
the steam knob to position “O”.
Problem Possible Reasons Measurement
Not enough heat or Too heat
Rotate thermostat dial improperly or
unplugging
Correct Thermostat dial in position and
check if the iron is plugged.
No steam or Leakage The thermostat dial has been set to MIN
Set the thermostat dial to the required
positioin.
No burst of steam or no
vertical steam
The (vertical) burst of steam function has
been used too often within a very short
period. The iron is not hot enough
Continue ironing in horizontal position and
wait a while before using the (vertical) burst
of steam function again
Leaking water from Soleplate
Set the thermostat dial out of steam range. Set the thermostat dial as per steam range.
The heat is still not enough.
Open steam button only after the indicator
light goes off.
The water is over than max position Pour out the remaining water
Little Steam
Check if the steam selector is in proper
location.
Set the steam selector to the proper
location.
Steam hole is blocked. Clean hole with distilled water.
Too little water in the water tank Fill water into the box
No Spraying No enough pressure or air inside
Press the spray nozzle by hand, and push
the spray button several times continuously.