Operating Seat Heaters
To control the front seat heaters for the driver
and passenger, touch the corresponding
control on the main climate control area at
the bottom of the touchscreen. To control the
rear seat heaters (if equipped) or access
duplicate controls for the front seat heaters,
touch the fan icon, then touch the seat heater
icon followed by the seat for which you want
to adjust heating. Seat heaters operate at
three setting levels from 3 (highest) to 1
(lowest). When operating, the associated seat
icon displays twisting lines that turn red to
indicate the setting level. You can touch
All
O to turn o all seat heaters simultaneously.
Adjusting the Front Vents
Model 3 has a unique horizontal face-level
vent that spans the width of the dashboard.
Using the touchscreen, you can pinpoint
exactly where you want to direct the air
flowing from this vent when heating or
cooling the front cabin area.
1. Driver vent and controls
2. Passenger vent and controls
When the face-level vent is on you can adjust
the direction of the air
flow from each vent.
To adjust the direction of the air flow, simply
touch the radiating air waves from the
corresponding vent on the touchscreen. The
air
flows in a single stream when centered or
splits into mirrored air streams when air is
directed outward or inward from the center of
the vent.
NOTE:
When you split a vent into two
separate air flows, the air flow in each
direction is not as strong as when all air is
flowing in a single direction.
NOTE: Outside air is drawn into Model 3
through the grill in front of the windshield.
Keep the grill clear of obstructions, such as
leaves and snow.
Adjusting the Rear Vents
Model 3 has vents located at the back of the
center console where air flows from when the
setting is turned on from the touchscreen. To
direct the
flow of air in the rear cabin area,
adjust the vents at the rear of the center
console up, down, or from side to side as
necessary.
Climate Controls
157Using the Touchscreen
To Next Page
Loading...
