• If the vehicle starts to charge, the issue
was likely with the equipment.
• If the vehicle still does not charge, the
issue may be with the vehicle.
Service should ONLY be scheduled if:
• You have tried charging with dierent
charge equipment / at dierent stations.
• This alert has appeared during every
charging attempt.
For more information on troubleshooting
Mobile Connector or Wall Connector status
lights, refer to the product's Owner's Manual.
If using other external charging equipment,
refer to the manufacturer's provided
documentation for troubleshooting tips.
(CP_a101)
Charging speed reduced
High temperature
detected by Wall
Connector
High temperature detected by Wall
Connector alerts indicate the building
connection to the Wall Connector is getting
too warm, so charging has been slowed to
protect the wiring and Wall Connector.
This is not typically an issue with your vehicle
or your Wall Connector, but rather an issue
with the building wiring. This may be caused
by a loose building wiring connection to the
Wall Connector and can be
fixed quickly by
an electrician.
To regain normal charge speed, contact an
electrician to inspect the building wiring
connection to the Wall Connector. They
should make sure that all wires are properly
connected and torqued according to the
installation guide for the Wall Connector.
Wall Connector installation guides can be
found here.
(CP_a102)
Charging stopped
High temperature
detected by Wall
Connector
High temperature detected by Wall
Connector alerts indicate the building
connection to the Wall Connector is getting
too warm, so charging has stopped to protect
the wiring and Wall Connector.
This is not typically an issue with your vehicle
or your Wall Connector, but rather an issue
with the building wiring. This may be caused
by a loose building wiring connection to the
Wall Connector and can be
fixed quickly by
an electrician.
To regain normal charge operation, contact
an electrician to inspect the building wiring
connection to the Wall Connector. They
should make sure that all wires are properly
connected and torqued according to the
installation guide for the Wall Connector.
Wall Connector installation guides can be
found here.
(DI_a201)
Regenerative braking
temporarily reduced
Will improve as vehicle is
driven
Regenerative braking performance has been
temporarily reduced to below 65% of its full
capacity. The exact reduction is indicated by
the dashed lines on the power meter:
Troubleshooting Alerts
256 MODEL 3 OWNER'S MANUAL
To Next Page
Loading...
