NOTE: As the USB flash drive runs out of
available space, the oldest footage in
Sentry Clips is deleted to make room for
new footage. Once deleted, you will be
unable to retrieve them. When the flash
drive is full, Sentry Mode and Dashcam can
no longer save video footage. To prevent
the
flash drive from getting full, you must
regularly move saved videos to another
device, and delete them from the flash
drive.
You can also review Dashcam and Sentry
Mode video recordings on your vehicle's
touchscreen by touching the Dashcam icon
and selecting "Launch Viewer". Each video,
organized by timestamp, provides footage of
a saved event from each camera. Touch the
thumbnail of any camera to enlarge the video.
Pause, rewind, fast forward, and delete video
footage as needed. Your vehicle must be in
Park to view Dashcam and Sentry Mode
footage on the touchscreen.
NOTE: Dashcam recording is paused while
the viewer is open.
NOTE: You are responsible for complying with
all local laws, regulations, and property
restrictions regarding video recordings.
NOTE: The cameras do not record audio.
Save Clips on Honk
Once a properly formatted USB flash drive is
inserted in one of the vehicle's front USB
ports, you can choose to save Dashcam clips
while driving when you honk the horn on your
steering wheel. Navigate to
Controls > Safety
and Security > Save Clips on Honk > ON to
enable. The most recent ten minutes of
footage is saved. You can also save Dashcam
footage by touching the Dashcam icon at the
top of the touchscreen.
Dashcam
94 MODEL 3 OWNER'S MANUAL
To Next Page
Loading...
