In the event that the key fob's battery is dead, you can
still use it to drive the vehicle by scanning the key fob on
the card reader located on the driver's side door pillar
(like the key card).
Instructions for changing the battery are provided in
Replacing the Key Fob Battery on page 9.
NOTE: You can use the same key fob with multiple
Model 3 vehicles provided you authenticate it (see
Managing Keys on page 10). However, key fob works
with only one Model 3 at a time. Therefore, to use a key
fob for a
dierent Model 3, touch its flat side against the
card reader on the driver's side door pillar.
NOTE: Model 3 supports up to four dierent key fobs.
CAUTION:
Protect the key from impact, high
temperatures, and damage from liquids. Avoid
contact with solvents, waxes, and abrasive
cleaners.
Passive Locking and Unlocking
Due to market region or vehicle configuration, passive
locking and unlocking may not be available for your
vehicle.
NOTE: Only key fobs with the TESLA logo printed on the
flat side support the passive locking and unlocking
feature. Key fobs with the MODEL 3 logo printed on the
flat side cannot passively lock and unlock Model 3.
Locking and unlocking Model 3 with your key fob is
conveniently hands-free. Although you must be carrying
a paired key fob, there is no need to use it. Model 3 has
sensors around the vehicle that can recognize the
presence of a key fob within a range of approximately
six feet (two meters). Therefore, you can keep your key
fob in your pocket or purse and simply pull on the door
handle to unlock. When carrying your key fob with you,
you can also open the trunk without having to use the
key by pressing the
rear trunk's exterior door handle. If
Walk-Away Door Lock is enabled, Model 3 automatically
locks when you exit and the key fob is no longer in range
(see Walk-Away Door Lock on page 12). Passive
locking and unlocking is automatically enabled when
you pair your key fob to
Model 3.
Although you can use the same key fob with multiple
vehicles, it can only be paired to one vehicle at a time.
To activate a paired key fob to a
dierent vehicle, touch
the flat side onto the driver's side door pillar and click
any button on the key fob to confirm.
NOTE: For increased security, passive locking and
unlocking disables after being stationary for five minutes
while within vehicle range when the vehicle is not in use
(for example, you are standing outside your vehicle). In
this situation, you must shake or press a button on the
key fob to re-enable passive locking and unlocking.
Replacing the Key Fob Battery
Under normal use, the accessory key fob (available at
https://shop.tesla.com) has a battery that lasts for up to
one year, depending on key fob version and selected
vehicle settings. When the battery is low, a message
displays on the touchscreen.
To replace the key fob battery:
1. With the key fob placed button side down on a soft
surface, release the bottom cover, using a small flat-
bladed tool.
2.
Remove the battery by lifting it away from the
retaining clips.
3.
While avoiding touching the battery's flat surfaces,
insert the new battery (type CR2032 ) with the ‘+’
side facing up.
NOTE: Wipe the battery clean before fitting and
avoid touching the battery's flat surfaces. Finger
marks on the
flat surfaces of the battery can reduce
battery life.
Keys
9Opening and Closing
To Next Page
Loading...
Need help?
General
