3. On top of the low voltage battery, lift the locking tab
that attaches the electrical connector to the
connector housing.
NOTE: The appearance of the electrical connector
and connector housing may vary, but the procedure
remains the same.
4.
On top of the low voltage battery, pull the connector
housing to the left. The electrical connector releases
from the low voltage battery.
5.
Release the cover from the red positive (+) jump
post, and then connect the
low voltage power
supply's red positive (+) cable to the red positive (+)
jump post.
CAUTION:
To avoid damaging Model S, do not
allow the positive cable to contact other metal
components.
6.
Connect the
low voltage power supply's black
negative (-) cable to the vehicle in the location
shown.
7.
Turn on the external power supply (refer to the
manufacturer’s instructions). Touch the touchscreen
to wake it up.
NOTE: It may take several minutes to receive enough
power to wake up the touchscreen.
8.
When external low voltage power is no longer
required, disconnect both cables, beginning with the
black negative (-) cable.
9.
On top of the low voltage battery, push the
connector housing towards the electrical connector
so that the electrical connector engages the
low
voltage battery.
10.
On top of the low voltage battery, push down the
locking tab that attaches the electrical connector to
the connector housing.
11. Replace the maintenance panel by placing it back in
its original location and pressing down until it is
secure.
12.
Close the hood.
Instructions for Transporters
205Roadside Assistance
To Next Page
Loading...
