Tesla MODEL S - Installing Latch Retained Child Safety Seats; Upper Tether Straps

10
OWNER SAFETY INFORMATIONCHILD SAFETY SEATS
INSTALLING LATCH RETAINED CHILD SAFETY
SEATS
Lower LATCH anchorage
points are provided at all three
rear seating positions and
are located between the seat
back rest and rear cushion.
The exact position of each
anchorage point is indicated
by the child safety seat
identification tab on the seat.
Although LATCH anchorage points
are provided at all three rear seating
positions, you can only use two at the
same time. To seat three children, use a
non LATCH retained child safety seat in
the middle.
When installing two LATCH retained child
safety seats, you cannot install them
adjacent to each other with one in the
middle and the other on the left (driver’s
side).
To install a LATCH
retained child safety
seat, attach the safety
seat onto the anchor
bars. Carefully read and
follow the instructions
provided by the child
safety seat manufacturer.
UPPER TETHER
STRAPS
If an upper tether strap is
provided, attach its hook to
the anchor point located on
the back of the rear seats.
Always position the strap so
that it runs over the center of
the ModelS head support,
except in cases where you are
installing a LATCH retained
child safety seat in the center
position—in this case, run the
strap over the left hand side of
the head support, as shown.
Tighten according to the child
safety seat manufacturer’s
instructions.
NOTE: To prevent the strap
from moving from side to
side, the top of the head rest
deforms.