Tesla MODEL Y 2012 - Page 125

NOTE: Regardless of the setting selected, the energy
gained by regenerative braking is reduced if the Battery
is full, or is extremely cold or hot (in which case, surplus
energy is used to heat or cool it).
NOTE: The regenerative braking setting is not available
on all vehicles.
Stopping Mode: Choose how you want Model Y to
behave once regenerative braking has reduced the
driving speed to a very low speed, Drive or Reverse is
still engaged, and both the accelerator and brake pedals
are released.
See Stopping Mode on page 62. You can
adjust this setting only when
Model Y is in Park.
Slip Start (on Rear-Wheel Drive vehicles): Turn on to
allow wheels to spin (see Traction Control on page 65).
O-Road Assist (on All-Wheel Drive vehicles): Enable
O-Road Assist to disable traction control and allow
wheels to spin when driving
o-road (see Traction
Control on page 65).
Charging
View charging status and adjust settings related to
charging Model Y (see Charging Instructions on page
162).
Autopilot
NOTE: Depending on market region, vehicle
configuration, options purchased, and software version,
your vehicle may not be equipped with all Autopilot
features described below.
Customize how some of the Autopilot features operate
to provide a safer and more convenient driving
experience. See About Autopilot on page 84 for an
overview of Autopilot components and features.
•
Autosteer (Beta): Turn on the feature that provides
automatic steering in addition to Trac-Aware Cruise
Control (see Autosteer on page 92).
•
Navigate on Autopilot (Beta): Navigate on Autopilot
automatically exits at o-ramps and interchanges
based on your navigation route and can also make
lane changes designed to prepare for exits and
minimize the driving time to your destination
(available only if your vehicle is equipped with the
Full Self-Driving option). Touch Customize Navigate
on Autopilot to specify how you want Navigate on
Autopilot to operate, such as whether you want it to
automatically enable at the start of every trip, how
you want it to perform lane changes, etc. (see
Navigate on Autopilot on page 97).
NOTE: Navigate on Autopilot is not available in all
market regions.
• Trac
Light and Stop Sign Control (Beta): Turn on if
you want Model Y to automatically stop at trac
lights and stop signs when using Trac-Aware Cruise
Control or Autosteer (see Trac Light and Stop Sign
Control on page 99) (available only if your vehicle is
equipped with the Full Self-Driving option).
•
Summon (Beta): Automatically park and retrieve
Model Y from outside the vehicle (see Summon on
page 108) (available only if your vehicle is equipped
with the Full Self-Driving option).
Customize Summon: Determine the bumper
clearance, distance, amount of side clearance, and
whether Summon requires continuous press to
operate (the ability to disable continuous press is not
available in all market regions).
Standby Mode: Use Standby Mode to eliminate the
delay that occurs when Smart Summon (if equipped)
is starting up.
•
Set Speed: When you engage Trac-Aware Cruise
Control or Autosteer, choose whether you want the
initial cruising speed set to the
Speed Limit or your
Current Speed (see Trac-Aware Cruise Control on
page 87).
•
Oset: When set to cruise at the speed limit, you can
choose a Fixed oset, in which the speed is adjusted
by a specific number of km/h on all roads, or a
Percentage oset, in which the speed adjustment
varies depending on the detected speed limit of the
road.
•
Blind Spot Camera: When ON, the touchscreen
displays the view from the corresponding side
repeater camera whenever you engage a turn signal
to change lanes. See
Blind Spot Camera and Collision
Warning Chime on page 115.
•
Blind Spot Collision Warning Chime: Choose if you
want a chime to sound when a vehicle is in your blind
spot and a possible collision is detected (see
Blind
Spot Camera and Collision Warning Chime on page
115).
•
Speed Limit Warning: Choose the type of warnings, if
any, you receive if driving speed exceeds the
detected speed limit (see
Speed Assist on page 120).
•
Speed Limit: Choose if you want Speed Limit
Warning to use a relative or an absolute speed limit
(see
Speed Assist on page 120). If you choose a
relative speed limit, you can specify an Oset to be
alerted only when you exceed the speed limit by the
specified oset amount.
• Lane Departure Avoidance: Choose if and how you
want the
steering wheel to respond if a front wheel
passes over a lane marking when the associated turn
signal is o (see Lane Assist on page 114).
• Forward Collision Warning: Choose if and when
Model Y displays visual and audible warnings in
situations when there is a high risk of a frontal
collision (see Collision Avoidance Assist on page 117).
Controls
123Using the Touchscreen