Tesla MODEL Y 2022 - Stopping or Canceling Smart Summon; Limitations

Standby Mode
To keep Model Y ready to Summon and
reduce the time it takes to warm up, turn on
Standby Mode. Touch Controls > Autopilot >
Standby Mode. When Standby Mode is turned
on, you can conserve Battery energy by
disabling Standby Mode at these locations:
• Exclude Home - Disables Standby Mode
at the location you set as Home in your
Favorites list.
•
Exclude Work - Disables Standby Mode at
the location you set as Work in your
Favorites list.
•
Exclude Favorites - Disables Standby
Mode at any location in your Favorites list.
NOTE: To conserve energy, Smart Summon
automatically exits Standby mode from
midnight to 6:00 am. During these hours, a
delay occurs as Smart Summon starts up.
NOTE: Additional battery power may be
consumed while Standby Mode is active.
NOTE: For details on how to designate a
location as Home, Work, or Favorites, see
Home, Work, and Favorite Destinations on
page 149.
Stopping or Canceling Smart
Summon
Smart Summon stops Model Y whenever you
release the button on the mobile app. To
resume the Smart Summon session, simply
press the
Come to Me or Go to Target button
again.
WARNING:
Always anticipate when
you need to stop Model Y. Depending
on the quality of the connectivity
between the phone and Model Y,
there may be a slight delay between
when you release the button and
when the car stops.
Smart Summon cancels, and requires you to
restart it, when:
•
A door handle is engaged or a door is
opened.
• You interact with the steering wheel,
brake pedal, accelerator pedal, or shift.
• Model Y is blocked by an obstacle.
•
Smart Summon has moved Model Y the
maximum distance of approximately
145
meters within a 65 meter radius of the
phone's location. To move further than
this distance, you must shift Model Y into
Drive or Reverse and then re-initiate an
Smart Summon session.
•
Your phone enters sleep mode or loses
connectivity to Model Y.
Limitations
Smart Summon is unlikely to operate as
intended in the following types of situations:
•
GPS data is unavailable due to poor
cellular coverage.
•
The driving path is sloped. Smart
Summon is designed to operate on flat
roads only (up to 10% grade).
•
A raised concrete edge is detected.
Depending on the height of the concrete
edge, Smart Summon may not move
Model Y over it.
•
One or more of the ultrasonic sensors or
cameras is damaged, dirty, or obstructed
(such as by mud, ice, or snow, or by a
vehicle bra, excessive paint, or adhesive
products such as wraps, stickers, rubber
coating, etc.).
•
Weather conditions (heavy rain, snow,
fog, or extremely hot or cold
temperatures) are interfering with sensor
or camera operation.
• The sensors are aected by other
electrical equipment or devices that
generate ultrasonic waves.
NOTE: Smart Summon is disabled if Model Y
is in Valet mode (see Valet Mode on page 52).
WARNING:
The list above does not
represent an exhaustive list of
situations that may interfere with
proper operation of Smart Summon. It
is the driver's responsibility to remain
in control of Model Y at all times. Pay
close attention whenever Smart
Summon is actively moving Model Y
and stay prepared to take immediate
action. Failure to do so can result in
serious property damage, injury or
death.
Smart Summon
122 MODEL Y Owner's Manual