Removing and Installing Aero Covers
If your Model Y is equipped with aero covers,
you must remove them to access the lug nuts.
To remove an aero cover:
1.
Grasp the aero cover firmly with both
hands.
2. Pull the aero cover toward you to release
the retaining clips.
To install an aero cover:
1. Align the aero cover into position so that
the notch at the base of the Tesla "T" is
aligned with the tire's valve stem.
2. Push firmly around the perimeter of the
aero cover until it fully snaps into place.
CAUTION:
To prevent the aero
cover from falling o, ensure that
it is fully secured before driving.
Removing and Installing Lug Nut
Covers
If your Model Y is equipped with lug nut
covers, you must remove them to access the
lug nuts.
To remove a lug nut cover:
1.
Place the curved part of the lug nut cover
tool (located in the glovebox for some
vehicles, or you can use a small allen
wrench) into the lowered perimeter
around the middle of the lug nut cover.
NOTE: The lug nut cover tool can also be
purchased at an auto parts store or
through online retailers.
2.
Twist the lug nut cover tool so that the
end of the curved part is facing away
from the Tesla "T".
3. Firmly pull the lug nut tool away from the
wheel until the lug nut cover is released.
To install the lug nut cover:
1. Align the lug nut cover into position.
2.
Push firmly on the lug nut cover until it
fully snaps into place.
Tire Care and Maintenance
194 MODEL Y Owner's Manual
To Next Page
Loading...
