1. Fully raise the head support by pulling it
upward.
2. Press and hold the button located at the
base of one of the posts.
3. Insert a short, flat object (such as a small
flat-head screwdriver) into the opening in
the base of the opposite post and pull the
head support upward.
To re-install the head support:
1.
With the front of the head support facing
forward, insert both posts into the
corresponding holes on the seat back.
2.
Press downward on the head support
until it clicks into place.
3.
Pull upward on the head support to
ensure that it is secure.
WARNING:
Ensure that the head
support is correctly installed before
seating an occupant. Failure to do so
increases the risk of injury or death if a
collision occurs.
Seat Heaters
The front and second row seats contain
heating pads that operate at three levels from
3 (highest) to 1 (lowest). To operate the seat
heaters, see Climate Controls on page 140.
WARNING:
To avoid burns resulting
from prolonged use, individuals who
have peripheral neuropathy, or whose
capacity to feel pain is limited because
of diabetes, age, neurological injury, or
some other condition, should exercise
caution when using the climate control
system and seat heaters.
Seat Covers
WARNING: Do not use seat covers in
Model Y. Doing so could restrict
deployment of the seat-mounted side
air bags if a collision occurs. Also, if
the vehicle is equipped with an
occupant detection system that is
used to determine the status of the
passenger front airbag, seat covers
may interfere with this system.
Front and Rear Seats
29Seating and Safety Restraints
To Next Page
Loading...
