5
ENG
10. Set the top door right
position,fix the top-hinge and
the cover.
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments
will not be covered properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise
loosening, tightening.
11. Install the four screw caps and two catches to
corresponding position.
- Ensure the Appliance is unplugged and empty.
- Adjust the two leveling feet to their highest position.
- We recommend you have someone to assist you.
12. Replace the leveler to the other side and adjust it to make
sure the cabinet level.
The unit’s door must be
able to open fully as shown.
W×D≥902×1052mm.
Door Space Requirements
Levelling the Unit
W
D
5. Replace the bottom door bearing bush and the limit block.
6. Replace the bottom hinge to the other side then fix it with
screws.
7. Replace the mid-hinge.
8. Set the bottom door right position,fix the mid-hinge.
9. Replace the top-hinge.
To Next Page
Loading...
Need help?
General
