• Require Continuous Press (U.S. Only): By
default, Summon requires that you press
and hold a button on the mobile app to
move the vehicle during the parking
process. When you set Require
Continuous Press to NO, you can:
• Park Model S by simply double
pressing the Park gear, specifying the
direction on the touchscreen (if
reversing), then exiting the vehicle.
• Park or retrieve Model S with a single
touch of a button on the mobile app.
• Park or retrieve Model S using the key.
• Use Auto HomeLink (if equipped): Set to
ON if you want to activate HomeLink to
open/close a programmed garage door
that meets safety standards during the
parking process. If enabled, the garage
door automatically opens and closes when
Model S enters or exits.
Note: This setting automatically opens
and closes the garage door only when
using Summon. To automate HomeLink in
other situations (such as when driving),
you must access the HomeLink device's
main settings by touching Controls >
Settings > HomeLink (see HomeLink
®
Universal Transceiver on page 131).
Warning: Do not use this setting with
gates or with a garage door that does
not meet safety standards. A garage
door opener that does not have
safety stop and reverse features
(cannot detect an object in its path
and then automatically stop and
reverse) does not meet these
standards. Using a garage door
opener without these features
increases the risk of injury or death.
Note: All settings associated with Summon are
retained until you manually change them.
Position the Vehicle for Parking
Before operating Summon, align Model S
laterally with the parking space so Model S
can move straight into the space in either
Drive or Reverse. You must also position
Model S within 39 feet (12 meters) of the
parking space (the maximum distance that
Summon can move Model S).
If applicable, open your garage door. As
described earlier, this can be automated using
Auto HomeLink (if equipped).
Note:
Use Summon on flat driveways only
where a raised concrete edge does not exceed
approximately 1 in (2.5 cm).
Operating Summon with the Mobile App
On the mobile app, start Summon and hold
down the forward or reverse button to move
Model S into the parking space. (U.S. Only): If
Require Continuous Press is set to NO (see
Customizing Summon on page 89), you do
not need to hold down the button, just touch
and release.
Summon shifts Model S into Drive or Reverse
(based on the direction you
specified) and
drives into the parking space.
Note: Summon cancels if your phone enters
sleep mode or is turned
o.
Operating Summon with the Key (U.S. Only)
Note: To operate Summon with the key,
Require Continuous Press must be set to NO
(see Customizing Summon on page 89).
Follow these steps to park Model S from
outside the vehicle using the key:
1. With Model S in Park, stand within 10 feet
(3 meters) and press and hold the top
center button on the key (Lock/Unlock All
button) until the hazard lights blink
continuously.
Note: The hazard lights
flash once as
Model S locks, then within five seconds,
Model S powers on and the hazard lights
flash continuously. Do not proceed to the
next step until the hazard lights are
flashing. If, after five seconds, the hazard
lights are not
flashing, release the button
on the key, move closer to Model S, and
try again. If Summon receives no further
input within ten seconds, Summon
cancels.
2. Press the Front Trunk (Frunk) button on
the key to move Model S forward into the
parking space, or press the Rear Trunk
button to reverse Model S into the parking
space.
Initiate Automatic Parking Before Exiting the
Vehicle (U.S. Only)
If Require Continuous Press is set to NO, you
can initiate the parking maneuver from inside
Model S before exiting:
Autopark
90 Model S Owner's Manual
To Next Page
Loading...
