2.5 TECHNICAL CHARACTERISTICS
Bull-wheels diameter: 1500 mm
Maximum conductor diameter: 40 mm
Maximum rope diameter: 18 mm
Diesel engine: 104 kW – 140 hp – 2400 rpm – turbocharged, after-cooler,
electronic type
Electrical system: 12 V
Transmission: hydraulic closed circuit with cooling system for hydraulic oil
Mechanical transmission 3 positions: neutral – maximum ratio (HIGH PULL) – minimum ratio (LOW
PULL) (standard for the 1
st
transmission – optional package
for the 2
nd
transmission)
Safety brakes: negative and self-acting type
Meter-counter: 2 electronic type
Axle: rigid type with mechanical stationary brake for towing at max.
speed of 30 km/h – 18,6 mph
Dimensions: length – 4075 mm – 160,4 in
width – 2360 mm – 92,9 in
height – 2800 mm – 110,2 in
Mass without oil: 6500 kg – 14300 lb
Updating & technical characteristic changes without notice are possible.
2.6 ACOUSTIC EMISSION
Level of continuous sound pressure at the operator’s position (UNI 9432) Lep = 85 dB(A)
2.7 GENERAL PRESCRIPTIONS FOR THE MACHINE USE
a. Only authorized and trained personnel must use the machine.
Trained personnel are intended to be the person who has received a qualified training from the using
Company or, as alternative, from the manufacturer.
b. Machine must be used only for the work it was designed for.
c. Machine cannot be used with non-authorized personnel on the working site.
d. For safety reasons, during transport machine comes without hydraulic oil and fuel.
Characteristics and required quantities are listed in the present manual.
e. For any doubt concerning use, functioning, maintenance or everything else, contact the After-sale
Service of the manufacturer.
2.8 GENERAL PRESCRIPTIONS FOR THE OPERATOR CHARGED OF THE MACHINE USE
a. Operator has to know safety directives for accident prevention in force in the machine using
country, for a correct use of the same.
b. The operator in charge with the installation and maintenance of the machine must use suitable
clothes to the working site and to the situation where he finds himself; in particular, he must avoid
the use of very large clothes, chains, bracelets, rings or whatever can get entangled with moving
parts of the machine.
c. The operator has to use the necessary protecting devices (i.e. gloves, boots, helmet, etc.).
It is compulsory the use of personal protecting devices for hearing.
d. The operator must not carry out on his own initiative operations or interventions that are not up to
him.
e. The operator must carefully follow danger and/or prohibition prescriptions contained in the
instruction manual or indicated on the machine.
f. The working area of the operator has to be cleaned from possible oil or liquids wastes and free of
materials or equipment that may be considered as on obstacle for the operator work.
g. The operator must absolutely avoid the direct inhalation of the exhaust gas of the endothermic
engine.
To Next Page
Loading...
