Need help?Do you have a question about the Tesmec DLR300 and is the answer not in the manual?
Company contact details and addresses for TESMEC S.p.A.
Describes the DLR300's function in monitoring and recording stringing parameters.
Detailed breakdown of the DLR300's components and controls.
Details on the capacity and format of recorded data.
Information on the voltage requirements for the DLR300.
Compliance with the Electromagnetic Compatibility Directive.
Instructions for connecting the DLR300 to the machine for monitoring.
Steps to power on the instrument and initial display information.
How to navigate to the instrument's main menu and select options.
Configuration of parameters for correct measurement and recording.
Adjusting the instrument's internal clock and date settings.
Adjusting screen contrast for better readability in various lighting conditions.
Procedures for starting and ending the data recording process.
Information on memory usage and recommendations for managing it.
Accessing, displaying, printing, saving, or deleting recorded operations.
Step-by-step guide for changing the thermal paper roll in the printer.
Overview of setting machine configuration and calibration parameters.
Inputting the company name for identification on printouts.
Configuring digital settings like capstan diameter and encoder pulses.
Adjusting analogue settings like sensor type and pull full scale.
Configuring functional aspects like pull resolution and direction mode.
Procedures for sensor reset and calibration of puller/tensioner.
Inputting the pre-assigned serial number of the instrument.
Recording the total operating hours of the instrument.
Saving, restoring, printing, or loading instrument configurations.
Indicates program data deletion; requires parameter verification.
Fault in backup flash memory; requires manufacturer repair.
Error in calculating encoder constant; review parameters.
Bit value acquired during calibration is too low or identical. Repeat calibration.
Calibration error due to identical or decreasing pull values. Repeat calibration.
Pull value mismatch with full scale bit; may limit max pull display.
Instructions for installing the bootloader software on a PC.
Specifies the necessary hardware and software for installation.
Step-by-step guide to install the necessary USB drivers.
Guide to install the firmware update software onto a computer.
Usage guide for the bootloader software for firmware updates and language changes.
Explains the purposes of the bootloader software, including firmware updates.
Instructions on how to start and use the bootloader software.
Detailed steps for updating the DLR300's firmware.
Procedure for adding a new language to the DLR300.
List of DLR 300 pull recorder spare parts with part numbers.
General| Brand | Tesmec |
|---|---|
| Model | DLR300 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
