Tesmec DLR300 - SETTING CONSTANTS AND CALIBRATIONS; STEPS TO SET CONSTANTS AND CALIBRATIONS; SETTING THE COMPANY NAME; SETTING THE DIGITAL PARAMETERS


Page 19



4. SETTING CONSTANTS AND CALIBRATIONS
4.1 STEPS TO SET CONSTANTS AND CALIBRATIONS
The machine-recording unit assembly requires a number of parameters to be defined, pertaining
to machine configuration and the intended use of the instrument as well as the calibration of the
entire pull detection system.
All these operations must be performed by the manufacturer
.
This programming level requires the user to access the main menu, then:
& Press: or to navigate the menu and select the MACHINE
PARAMETERS function
♦ Select: MACHINE PARAMETERS
& Press: to access the machine parameter management page
 The following appears: PASSWORD: 0000
& Press: or until the desired individual number is selected.
& Press: to move on to the next number of the activation code of the
parameter programming operations of the machine and instrument
or
& Press: to exit the code entry page and return to the main menu.
 The following appears: COMPANY NAME
DIGITAL PARAMETERS
ANALOGUE PARAMETERS
FUNCTIONAL PARAMETERS
CALIBRATIONS
SERIAL NUMBER
OPERATING HOURS
4.1.1 SETTING THE COMPANY NAME
♦ Select: COMPANY NAME
& Press: to access the company name setting page
 The following appears: COMPANY SETTING
- C TESMEC - ITALY (or another pre-set company name)
& Press: to select the individual character to be changed
& Press: or to select the correct character until the desired text is
entered
& Press: to confirm the text and return to the machine parameters setting
menu.
or
& Press: to exit the name setting window without saving the changes and
return to the machine parameters setting menu.
4.1.2 SETTING THE DIGITAL PARAMETERS
& Press: or to navigate the menu and select the DIGITAL
PARAMETERS function
♦ Select: DIGITAL PARAMETERS
& Press: to access the settings page of the digital parameters