2. GENERAL INFORMATION AND REQUIREMENTS
2.1 MANUFACTURER
TESMEC S.p.A.
Via Zanica, 17/O
24050 - GRASSOBBIO
BG - ITALY
tel. (+39)-035-4232911
fax (+39)-035-4522445
e-mail: info@tesmec.it
Via Pertegalli, 2
24060 - ENDINE GAIANO
BG - ITALY
tel. (+39)-035-825024
fax (+39)-035-826375
e-mail: info@tesmec.it
2.2 TYPE AND FIELD OF USE
The DLR300 pull recorder is an electronic device that monitors and records the stringing
parameters of overhead lines or the laying of underground lines.
The following characteristic data is displayed in real time:
- cable stringing/laying length
- the pull value applied with confirmation of a pre-set limit value being exceeded
- instantaneous speed of cable stringing/laying
the data is saved simultaneously with the following:
- date and time monitoring begins
- pull limit value that must not be exceeded
- sampling interval
- date and time monitoring ends.
The DLR300 can record and save the data of individual cable stringing or laying operations in its
internal memory. The saved data can be recalled at a later stage to be printed or exported to a
USB flash device. The data exported to a USB flash device can then be downloaded and viewed
on any Personal Computer.
The DLR300 recorder can be configured with the parameters of the machine it will be connected
to, using the USB flash device. This procedure allows the DLR300 to be connected to machines
with different features, by transferring the relative configuration parameters to the recorder.
In the DLR300 pull recorder and manual, "CABLE LAYING" refers to both "stringing" and "laying"
operations.
ATTENTION:
We cannot guarantee compatibility with all USB flash drives on the market.
The DLR300 recorder can monitor and save the data of individual cable stringing
or laying operations of the machines it is connected to but cannot intervene on
their operation.
To Next Page
Loading...
