PULLER-TENSIONER
Model: AFS404
Manual: MI-AFS404-609-01-GB
4.13.3 SWITCHING THE HEATER ON (OPTIONAL)
Manually: by pressing the button (continuous heating mode).
Automatically: by programming the heater starting time.
4.13.4 SWITCHING THE HEATER OFF (OPTIONAL)
Manually: by pressing the button .
Automatically: after the programmed operating time has elapsed.
With the heater running: by programming the remaining operating time.
4.13.5 SETTING TIME/DAY OF THE WEEK (OPTIONAL)
Press the button for more than 2 seconds – time of the day is flashing.
Set the clock using the and buttons – day of the week is flashing – adjust the day of the week.
4.13.6 VIEWING THE TIME (OPTIONAL)
With the ignition switched off: press the button.
4.13.7 PROGRAMMING HEATER STARTING TIME (OPTIONAL)
Press the button – the memory location is flashing – using the and buttons set start of the
heater operating time. Day of the week is flashing – set the day of the week.
By repeatedly pressing the button, memory locations 2 and 3 can be programmed or the time
display mode can be reached.
4.13.8 RECALLING/ERASING PRE-SET TIMES (OPTIONAL)
Repeatedly press the button until the desired memory location is displayed.
To erase the pre-set time, press the button several times until the time of the day is displayed
instead of the memory location.
4.13.9 PROGRAMMING DURATION OF OPERATING TIME (OPTIONAL)
The heater must be switched off. Press the button for 3 seconds – operating times is flashing –
and set the desired operating time (10 to 120 minutes) using the and buttons.
4.13.10 SETTING THE REMAINING OPERATING TIME (OPTIONAL)
Set the desired remaining operating time (1 to 120 minutes) using the and buttons.
The remaining operating time refers to the time the heater still continues to remain in operation.
It can only be changed while the heater is in operation and the ignition switched off.
4.13.11 SETTING THE WAKEUP TIME (OPTIONAL)
A wakeup time can only be programmed on the standard digital timer.
The wakeup time is not bound to a specific day of the week.
Repeatedly press the button until the bell symbol appears on the display.
Set the desired wakeup time using the and buttons.
The alarm clock turns off after 5 minutes or when one of the buttons is pressed.
To Next Page
Loading...
