GETTING STARTED - UNPACKING THE BOX
Your Cibola was shipped with these parts:
1 Upper Pole Assembly
Fully assembled, including upper pole stem with handle grip, padded arm bracket and control
housing.
1 Middle Pole Assembly With Pole Lock
1 ABS Lower Pole Assembly
Fully assembled, complete with two friction washers, mounting screw, and thumb nut.
1 9 x 8 Monolithic Searchcoil With 3’ Cable and Scuff Cover
1 9 Volt Alkaline Battery
1 Operator Instruction Manual
1 Tesoro Warranty Card
If any of these items are missing, contact the Tesoro Authorized Dealer where you purchased
your detector immediately.
Assembling the Cibola is simple and requires no special tools. Just install the battery packs,
mount the searchcoil on the lower pole assembly, connect the pole assemblies together, wrap the
excess cable around the pole and plug the cable into the control housing. Finally, adjust the pole
length and searchcoil angle and you're ready!
To Next Page
Need help?
General
