To Next PageTo Next Page
Need help?Do you have a question about the Test Equipment Depot NRP6Di and is the answer not in the manual?
General| Brand | Test Equipment Depot |
|---|---|
| Model | NRP6Di |
| Category | Water Pump |
| Language | English |
Connect the vacuum pump to the AC system for power.
Turn the power switch on; the screen will illuminate.
Press the Start button to run the pump and the UNIT button to change measurement units.
Press the Start button to stop the pump if needed, then turn off the power switch and disconnect.
Notes on beep after reaching 500 micron, sensor readings, and suitability for refrigerants.
