TESTO 512 - Page 10

5. Operation30
2
Setting tthe uunit oof ppressure:
 The configuration modus is open, the set unit blinks.
i Set the desired unit with / and confirm with
.
3
Setting tthe pparameter ffor tthe llower mmeasurement vvalue
line:
The parameters temperature (internal temperature
sensor) or flow (versions 2hPa, 20hPa and 200hPa only)
can be displayed in the lower measurement value line.
 The configuration modus is open, °C°F lights up.
1 Select the desired option with / and confirm
with :
· On: The temperature measurement value is
displayed in the lower measurement value line,
except when the display of flow measurement
value is activated (versions 2hPa, 20hPa and
200hPa only).
· OFF: The temperature measurement value is not
displayed in the lower measurement value line.
OFF is selected, Version 2000hPa:
º Next handling objective 4 SET DAMPING.
OFF is selected, Versions 2hPa, 20hPa and 200hPa:
- m/s and fpmx100 light up.
º Next step 3.
On is selected:
- The set temperature blinks.
2 Select the desired unit with / and confirm
with :
Version 2000hPa:
º Next handling objective 4 SET DAMPING.
Versions 2hPa, 20hPa and 200hPa:
- m/s and fpmx100 light up.