6 Using the product
37
• The radio probe is outside the range of the instrument.
• Sources of interference are influencing radio transmission (e.g.
reinforced concrete, metal objects, walls or other barriers
between transmitter and receiver, other transmitters of the
same frequency, strong electromagnetic fields).
> If necessary: Rectify the possible causes of the fault in radio
transmission.
2. Press [OK] to enable (
) or disable ( ) the radio
connection.
3. Move Joystick right to switch to a list of the radio probes found.
4. Move Joystick up/down to select a probe.
- The selected probe is highlighted orange (
).
5. Confirm selection with Apply.
If no readings appear during the measurement:
> Check the potential causes, see above.
Audio settings…
The volume of the audio playback and recording can be set.
1. [OK] | Configuration… | [OK] | Audio settings… | [OK].
- The Audio settings... dialogue is opened.
2. Move Joystick up/down to select the desired option.
- The selected option has an orange border (
).
3. Move Joystick left/right to change the setting.
4. Confirm the settings with [Apply].
Format…
The memory card can be formatted. During the formatting, all
saved data on the SD card is lost.
1. [OK] | Configuration… | [OK] | Format… | [OK].
- A confirmation request appears as to whether the memory card
should really be formatted.
2. Confirm with [OK] or cancel process with [Esc].
1.800.561.8187 info@Testo-Direct.ca
www.Testo-Direct.ca
To Next Page
Loading...
Need help?
General
