What to do if my Tetra WP 300 Water Pump has insufficient flow of water?
If your Tetra Water Pump isn't flowing enough water, it might be clogged, faulty, or have a worn impeller. Try cleaning the pump first. If that doesn't work, the impeller might need replacing. If problems persist, contact your retailer or Tetra Customer Service.
Why my Tetra WP 300 will not operate?
If your Tetra Water Pump isn't working, there could be a few reasons. First, check if the pump is properly connected to a power supply. If it is, the pump itself might be faulty, or the impeller could be blocked. Try cleaning the pump to remove any blockage. If the problem continues, contact your retailer or Tetra Customer Service.
General| Flow Rate | 300 l/h |
|---|---|
| Max Head | 0.5 m |
| Voltage | 220-240 V |
| Max Flow Rate | 300 l/h |
| Cable Length | 1.5 m |
To Next Page
