Teuco 629 - WATER TREATMENT; PUMP; TEMPERATURE ADJUSTMENT OF THE WATER

22
629
EN
37.0
INSTRUCTIONS FOR USE
TEMPERATURE ADJUSTMENT OF THE WATER
Press the “
q
” and “p” keys to set the temperature of
the water in the minipool at 0.5°C graduations.
The temperature of the water in the tub is visualised
on the display.
The set value is visualised during the adjustment of
the temperature.
A warning light
lights up and the heater switches
on, If the temperature of the water in the minipool is
less than the set temperature.
The temperature can be set between 15°C
and 40°C.
PUMP
Press the “Pump” key once to actuate all the
hydromassage functions at low power.
The LED flashes.
Press the “Pump” key again to actuate the massages
at full power.
The LED remains on.
Press the “Pump” key a third time to stop the
massages in advance.
The LED switches off.
After 20 minutes of continuous functioning,
the hydromassage switches off automatically.
4 - WATER TREATMENT
Treat the water with products supplied by Teuco, as described in the attached manual.
Equivalent products can also be utilised.
Check that the pH value of the water is between 7.2 and 7.6 inclusive and the quantity of
chlorine is between 1 and 1.5 ppm.
The chemical control of the pH and the chlorine in the water must be effectuated frequently to
ensure the quality of the water and the correct functioning of the hydromassage unit.